PLASMA SOUND PC 6061/T
Type | Ardent cutting |
Scope | Industrial |
Weight | 26,0 kg |
Width | 286 mm |
Depth | 515 mm |
Height | 406 mm |
Guarantee | 24 months |
The new POWER PLASMA 60611T installation is a three-phase power supply for plasma cutting of metals. Thanks to existence of a manual torch of CP 101 MAR the recommended thickness for the best quality of cutting and productivity is equal to 20 mm; the maximum thickness is 25 mm and extreme thickness - 30 mm.
The new POWER PLASMA 60611T installation is a three-phase power supply for plasma cutting of metals.
Thanks to existence of a manual torch of CP 101 MAR the recommended thickness for the best quality of cutting and productivity is equal to 20 mm; the maximum thickness is 25 mm and extreme thickness - 30 mm.
The small size and weight do PLASMA SOUND PC 60611T by ideally suitable device for manual cutting on productions of the average size (60A@60%) where there is a three-phase food, and also for small works in the automatic mode, thanks to speed are sharp also to high efficiency of a continuous cycle (50a@100%).
- Automatic change of tension (208V-220V-2ZOV-400V-440V +/-10%).
- Automatic system of verification of a phase (both at start, and in operating time), in order to avoid damage of installation at casual lack of a phase.
- The Post-gas function which cools a torch after switching off of an arch that promotes undervoltage of components of a torch and allows to increase service life of expendables.
- Work with an arch on duty that allows to work at metals with paint and varnish or other covering.
- The bridge scheme allows to reduce idling tension.
- The function of automatic restart of an arch (Self Restart Pilot) on duty chosen directly from the control panel and which automatically interrupts and restores an arch when cutting grids and lattices, increasing the operator's productivity.
- Ignition of an arch with high frequency that guarantees reliable excitement of an arch on duty and reduces hindrances.
- High electromagnetic compatibility according to the EN60974-10 standard that allows to use the device in close proximity to the electronic equipment (such as computers, PLK, etc.).
- The central fastening of a torch with the protection device for the prevention of casual contact with the parts which are energized.
- Explosion-proof execution of the block of a reducer of air.
- Serial complete set: the torch of CP 101 MAR, length of a hose is 6 m.
Conforms to the EN 61000-3-12 standard.
The power supply can be used from a power line of the diesel generator.
Extract from the table of cutting | ||
Low-carbonaceous steel - Mild Steel | ||
Current (A) | Thickness (mm) | Speed of cutting (m/min) |
60 | 3 | 6.25 |
10 | 1.51 | |
15 | 0.51 | |
20 | 0.42 |
Low-carbonaceous steel - Stainless Steel | ||
Current (A) | Thickness (mm) | Speed of cutting (m/min) |
60 | 3 | 6.10 |
8 | 1.45 | |
15 | 0.40 | |
20 | 0.27 |
Aluminum - Aluminium | ||
Current (A) | Thickness (mm) | Speed of cutting (m/min) |
60 | 3 | 7.10 |
8 | 2.45 | |
12 | 1.35 | |
20 | 0.42 |